Call Jim Macke Bindery Machine Service for emergency repairs or just routine maintenance on your Müller Martini Bindery Equipment.

Equipment Moving- Let us help you relocate your Bindery Equipment.

Our equipment moving services can help you relocate within your facility or move to a new location. We will move equipment anywhere within the continental USA. Jim Macke Bindery Machine Service securely places each section on wood and uses our own semi to assure your equipment is relocated without damage.

[Top]


Bindery Equipment Rebuild – We can do your rebuild onsite or at our location.

                                                            

The machine is first completely disassembled to the Frame. The complete Frame and all sub- components are cleaned, degreased and repainted as necessary to achieve an “as-new” appearance. Any Panel Cover or Enclosure that exhibits minute or no signs of wear or damage is cleaned and reinstalled ''as-is''. Every Shaft is removed, inspected and replaced as required by Original Equipment Manufacturer parts or remanufactured to strict OEM specifications in our machine shop. Sprockets and Gears are removed, inspected and any sign of wear exceeding 10% of their original new condition are also replaced with new OEM parts. All Belts and Chains are automatically replaced with new parts unless there is evidence they have been replaced within approximately the last 100 hours of machine running time. All components, major and minor, are removed, inspected and checked to insure they meet stringent OEM tolerances. The Primary Drive Motor is completely rebuilt with new Bearings, Seals and Gaskets and the Armature is checked both electrically and mechanically to insure it is in optimum condition. All Oil Lines, Air Lines, Fittings, Restrictors and associated components are replaced as needed. The machine is then reassembled and all Lubrication Lines are terminated to their appropriate delivery point, bled and finally checked for correct flow and pressure as dictated by OEM specifications. The completely rebuilt machine is finally reinstalled, retimed and test run in your existing line. Completely rebuilt machines are covered by a six month parts only warranty that goes into effect on completion of the final installation. Unless other arrangements are negotiated and documented in writing, this warranty is extended only if the machine is either installed or the installation is inspected and approved by Jim Macke Bindery Machine Service, Inc.

[Top]

Bindery Equipment Reconditioning – Our qualified technicians can recondition your equipment with a minimal amount of down time.

A complete inspection will be performed and any part, including but not limited to, Main Shafts, Chains, Sprockets, Gears and/or Bearings that exhibit signs of wear in excess of 25% will be repaired or replaced as necessary. All missing or damaged parts will be replaced. The units will be test run in our shop and the reconditioning process will result in this equipment being in above average condition. After reconditioning these units will be covered by a thirty day parts only warranty that goes into effect on completion of the final installation. Unless other arrangements are negotiated and documented in writing, this warranty is extended only if the machine is either installed or the installation is inspected and approved by Jim Macke Bindery Machine Service, Inc.

[Top]